You should be able to ping 192.168.1.1 however.ĥ. You will not be able to browse to the WRT54 at this point, and the power light may be off. Unplug the power cord again and plug it back in (power cycle unit).Ĥ. Power cycle the router by unplugging the power cord, then plugging it in.ģ. You will see a dialog to Reboot the device. Use the firmware upgrade dialog to flashġ. Push the reset button while plugging in the power cord and hold the button for about 20 seconds.ĥ. Unplug the power cord from the WRT54Gv8.ģ. Configure your local lan ethernet address to 192.168.1.100, subnet 255.255.255.0, gateway 192.168.1.1 and connect your local ethernet to your WRT54Gv8 on one of the 4 switch ports (note that the tftp step below may not work unless you are plugged into port 1).Ģ. How To Flash the WRT54G v8 (from flashing.txt)ġ. I am guessing your on step 4? After the vxworkskillerGv8.bin flash? If you do not follow the instructions correctly then yes its possible to brick it.ĭid you set your interface to 10MB half duplex?
But still there are multiple steps that need to be performed in a specific order. Flashing dd-wrt to a v8 wrt54g is a multi step process, where in the process did you go wrong? Sure they are so simple a retarded monkey on crack could do them.
0 kommentar(er)
